Quick answer

Work out when the buzz happens before touching anything. NZXT’s guide for its AIO coolers says rattling, clicking and buzzing are usually a fan, not the pump. A high-pitched electrical whine is coil whine, which Corsair calls a byproduct of working components rather than exactly a defect. Grinding from a hard drive means power down and back up your data. Never open a power supply.

Contents

At a glance

Class
Tutorials

Provenance

  • Nov 18, 2026Published

A buzz from a PC doesn’t name its own source, so the job is to sort it. The vendor pages I read cover five sources of buzzing, humming or whining: a fan, coil whine, a hard drive, a liquid cooler’s pump, and the power supply. The cheapest sorting tool is a question: when does it happen?

What you noticeWhat the vendor pages say it isFirst safe check
Rattle, click or buzz from a PC with a liquid coolerNZXT’s AIO guide: “usually a fan, not the pump”Power off, then check mounting, blade contact, dust
High-pitched electrical whine, often under loadCoil whine; Corsair calls it a byproduct of working componentsCompare against the coil whine guide
Noise that comes with drive activity, or from the drive bayDrive sounds, covered by Seagate and Western DigitalBack up first, then test the drive
Gurgling near the radiatorAir in the pump, per NZXTSee the AIO pump check
Grinding that gets worse over weeksNZXT lists this as a failing pumpContact the cooler’s maker

Never open the power supply to look for the noise. More on that below.

Start by writing down when it happens

This part is my method, not a vendor’s. Before you pull a side panel off, note whether the buzz is constant, only under load, only when the drive is being read, only at startup, or only after the PC has been running a while. The answer decides which section below to read, and a phone recording held near the case helps if you end up talking to support. Corsair’s own support page asks you to find the serial number and open a ticket, and a recording is easier to describe than a sound.

A buzzing fan

Corsair’s fan guide has the plainest checklist I’ve found, and it’s written for Corsair fans, though I’d run the same checks on any case fan:

  • Check the installation. Each fan should be seated and secured in its mount. Corsair says loose screws or improper installation can cause vibrations.
  • Clean the fans. Dust and debris can cause noise. Corsair says to turn the system off first and then gently clean the blades and the area around them.
  • Look for obstructions. Corsair says to check for wires or foreign objects touching the blades, and that even a slight touch can make noise.
  • Set a consistent fan speed. Corsair says doing that in iCUE can eliminate clicking caused by variable fan speeds, or help isolate the issue.

If the noise persists after those, Corsair says to contact its support team about a replacement.

One more check comes from NZXT’s cooler troubleshooting article. It says to power off the PC and disconnect the affected fan first, then spin it by hand. NZXT says a working fan should spin freely and slow gradually, and that a fan that stops suddenly or resists likely has a seized motor.

I’d keep your hands out of a running case. NZXT’s articles do describe stopping each fan one at a time to find the noisy one, and I’m not repeating the by-hand method here. NZXT says not to attempt to stop its high-performance F120X and F140X fans by hand, that those fans carry enough force to cause serious injury, and that they should be stopped through software or by disconnecting power. If the fan in question is the CPU fan and it’s stopped rather than noisy, the CPU fan guide is the right page.

Coil whine: the high-pitched electrical one

NZXT describes it as a high-pitched buzzing or whining sound caused by electrical current. In its AIO guide, a high-pitched electrical whine from the pump motor is listed as coil whine and as normal.

Corsair’s explanation for power supplies is short. When the current through an inductor changes, the magnetic field changes, and the coil’s small attraction and repulsion shows up as vibration and sound. Corsair says all power supplies generate it, and that many have sound-dampening material to reduce it. Its words on defects: coil whine is “not exactly a defect, but rather a byproduct of the components working as intended.” If you’re worried about your unit, it says to create a ticket with its support team.

I won’t repeat the GPU-versus-PSU sorting here. The GPU or PSU coil whine guide walks through that with a frame-rate cap and fan-speed notes, and the coil whine database collects owner reports by model.

A buzzing, humming or clicking hard drive

Hard drives are the one source where the vendors give you a clear line between normal and not.

Seagate’s sounds page is written for its Seagate and LaCie external drives, and it says clicking during reads and writes is a sign the drive is active, a hard click can happen when the heads park at shutdown or sleep, and platter spin typically makes a whirring sound. It lists a hard click that persists or comes with repeating clunking or grinding as pointing to a likely physical problem. Western Digital says good drives make clicking noises every few seconds, and that random clicking is normal on helium-based drives.

Neither page I read uses the word “buzzing.” Western Digital’s list of strange sounds during normal operation includes humming and vibration, and adds that vibration may come from mounting; its suggestion for internal drives is rubber strips between the drive and the case.

The sounds to act on:

  • Grinding. Seagate’s troubleshooter says to power the drive down immediately to avoid further damage. Seagate’s sounds page says that if you need the data, contact Data Recovery Services before troubleshooting.
  • Repeated, regular tapping, beeping or clicking. Seagate calls these possible indicators of abnormal function, and says two hard clicks at startup followed by a boot error or shutdown is a symptom of a failed drive.
  • Any sound with a drive you can’t afford to lose. Seagate says it’s always important to make an immediate backup if a drive failure is possible.

To confirm the noise is the drive, Seagate’s page for noisy drives describes an acoustical spin-down test in SeaTools that temporarily spins down internal drives. If the sound stops when the drive spins down, the drive is making it; if the sound stays, the drive isn’t the cause. Seagate points to its Document ID 201271 for the steps, which I haven’t read. For health numbers on any brand, the hard drive health check covers SMART values.

A pump buzzing or clicking

If you have a liquid cooler, NZXT’s guide splits the noises this way: gurgling or bubbling is air in the pump or radiator and worth fixing; rattling, clicking or buzzing is usually a fan, so check the fans first; a high-pitched electrical whine is coil whine from the pump motor and normal; grinding, or noise that worsens over weeks, is a failing pump and means contacting support. That table is for NZXT coolers, and I use a Kraken 360, but the logic of ruling out the fans first is general.

NZXT’s air-clearing steps are specific to its pump design, so I’ll leave them in its article and not paraphrase them. The one general point is that NZXT says if the noise persists after two air-clearing attempts or worsens, you contact support. For how to check the pump itself, the AIO pump guide covers reading the tach.

A buzzing power supply

Corsair’s guidance on a PSU buzz is the coil whine explanation above. I don’t have a manufacturer source for how to tell a power supply’s own noise from a graphics card’s beyond the site guide linked there, and I won’t make one up.

What I can source is what not to do. Corsair’s manual says high voltages are present in the power supply, and: “Do not open the power supply case or attempt to repair the power supply; there are no user-serviceable components.” It also says failing to comply with the manufacturer’s instructions or its safety instructions will immediately void all warranties and guarantees. So the isolation for a power supply happens outside it. The only controlled test I’d run is a swap with a compatible known-good unit and its own cables, or I’d hand the unit to the maker. For the swap, Corsair’s manual starts by disconnecting the AC power cord from the wall outlet and from the existing power supply, and it says not to insert any objects into a power supply’s ventilation or fan grill. The PSU failure guide covers that swap and its limits.

When it’s a warranty matter

Each vendor draws the line slightly differently, so check your own warranty. What I read:

  • Fans: Corsair says if the noise persists after its checks, contact support and they can assist with a replacement. NZXT says to contact its support team for a replacement under warranty.
  • Liquid cooler: NZXT says if noise or overheating continues after a second round of its steps, the cooler may need replacing. It says not to open the cooler to drain or clean the coolant, because that is not covered under the limited warranty. NZXT lists 6 years for Kraken Elite, Plus and 2023 models, 5 years for Core, and 3 years for Kraken 120, counted from purchase at an authorized reseller.
  • Power supply: Corsair treats coil whine as not exactly a defect and invites a support ticket. Opening the unit is the thing that risks the warranty.
  • Hard drive: Seagate’s FAQ says a replacement needs the drive in warranty, passing a visual mechanical inspection without being opened or modified, and failing the SeaTools test where that applies. It says its limited warranty does not cover data loss or recovery costs. The FAQ is marked Rev. July 2016, so confirm the current terms. Seagate’s noisy-drive page says to replace a drive that fails SeaTools.

If the noise is loud, getting worse, or comes with shutdowns or errors, stop troubleshooting and contact the maker. A recording and the serial number save a round of emails.

Frequently asked questions

Why is my PC making a buzzing noise?
A buzz can come from a fan, from coil whine in the GPU, power supply or pump motor, from a hard drive, or from a pump. Sort them by when the noise happens. NZXT’s guide for its AIO coolers lists rattling, clicking and buzzing as usually a fan and high-pitched electrical whine as coil whine. Seagate and Western Digital document drive sounds separately, with grinding as the one to act on at once.
Why is my PC fan making a buzzing noise?
Corsair’s fan guide gives the first checks: confirm each fan is seated and secured, because loose screws or improper installation can cause vibration; clean the blades with the system off; look for wires or objects touching the blades; and set a consistent fan speed to isolate the problem. If the noise persists, Corsair says to contact support for a replacement.
What does electrical buzzing sound like?
NZXT describes coil whine as a high-pitched buzzing or whining sound caused by electrical current, and lists high-pitched electrical whine as normal when it comes from a pump motor. Corsair explains that changing current in a coil makes it vibrate, which shows up as sound, and that all power supplies generate this to some degree.
What does a failing PC fan sound like?
Corsair says unusual noise or clicking from a fan is a sign something is not right. NZXT lists grinding, or noise that worsens over weeks, as a failing pump rather than a fan, and says a fan that stops suddenly or resists when you turn it by hand, with the PC powered off and the fan disconnected, likely has a seized motor. I would not call a fan failing from the sound alone.
What are the signs of a failing PC?
Noise is only one signal. For a hard drive, Seagate lists grinding, repeated tapping or clicking, and two hard clicks at startup followed by a boot error as signs of abnormal function or a failed drive. For a liquid cooler, NZXT lists sudden shutdowns under load and unusually high idle temperatures. Power supply faults overlap with other parts, so use the PSU failure guide before blaming one.
Is a buzzing power supply dangerous?
Corsair describes power supply coil whine as not exactly a defect. The danger is opening the unit. Corsair’s manual says high voltages are present and tells you not to open the case or try to repair it, because there are no user-serviceable components. If a power supply is noisy and you want it handled, contact its maker.
Is a hard drive buzzing or humming normal?
Seagate describes whirring from spinning platters as normal and clicking during reads and writes as normal. Western Digital lists humming and vibration among strange sounds during normal operation, and says vibration may come from mounting. Neither page I read uses the word buzzing, so judge by the specific sound: grinding means power down and back up data.

Sources and corrections

Last updated
Methodology
See our methodology for research and review standards. It draws on 11 cited sources, listed below, each checked against the original page on 2026-11-17. Written 2026-11-17 from the vendor pages listed below, each opened that day. I ran no commands on a machine of mine for this page, and I am not describing a noise I measured or recorded. Where a vendor page covers one product line, such as NZXT Kraken coolers or Corsair fans, I say so. Seagate’s pages are undated and show a 2026 copyright footer; Western Digital’s answer shows an update of 2026-11-09; the Corsair help articles show 2024-10-23; the NZXT AIO blog post shows 2026-08-17.
Corrections
Spotted an error? Email a correction with the affected line and what you found. The draft includes this page’s address. Verified changes are recorded here. Contact details.

About the author

I am Lowell K. Wood IV. I research, write and maintain everything on TechFuelHQ from St. Louis County, Missouri.